Journal Entry 10

So, here she is. If you read my last blog post (Journal Entry 9) i found something that i could use 3D printing to help my life. The cords under my desk are a complete mess, and i like my sh*t tidied up. So, i designed a “Cord Organizer” if you can call that, to help me out. In the previous post (Once again, Journal Entry 9) i posted a picture of what under my desk looks like. So this “Cord Organizer” is designed specifically for that desk. The metal bar underneath the outlet on the wall is aprox. a 18 mm (width and height) cube/ rectangular prism thingy . I made sure that the clasp of this device can and will fit the bar (width wise) and made sure the sides are long enough (height wise) to snugly keep it in place. The big, circular hole is about 50 mm (5 CM) in diameter, with about 48 mm of actual space (2mm are used as en edge kinda deal). This hole is connected to the base by the top and should be big enough to both fit the heads of the electrical cord through and keep multiple wires contained in it. Hopefully this design works out and it should be relatively easy to print (Might need some supports here and there). But in the end, this is my “Cord Organizer”.